Using The Zr 5 Remote Control - NAD M15 HD Owner's Manual

OPERATION
USING THE HTRM REMOTE CONTROL
BATTERY INSTALLATION
Press in and lift tab to remove battery cover out from recess
Place batteries into opening. Ensure the correct polarity is observed
Press battery cover into place until it 'clicks' closed
SLEEP MODE
The Sleep Mode timer will switch the M15 HD to Standby mode
automatically after a preset number of minutes. Pressing the HTRM's SLEEP
button once will display the setting of the sleep time increment. Pressing
the HTRM's SLEEP button a second time within a 3-second period will
change the sleep time increment in 15-minute intervals, after which time
the M15 HD will automatically switch into Standby mode.
To adjust the sleep delay, press the HTRM's SLEEP button twice; first
to display the sleep time increment, and a second time to change the
sleep time increment. The sleep time increment and a "SLEEP" icon will
continuously display on the M15 HD's front panel Vacuum Fluorescent
Display (VFD). Each consecutive press increases the sleep time in 15-minute
increments from 15 to 90 minutes. To cancel the sleep mode, continue
pressing the HTRM's SLEEP button until "SLEEP OFF" displays on the VFD.
Switching the M15 HD to standby from either the HTRM's OFF or the
M15 HD's STANDBY button will also cancel the sleep mode
40

USING THE ZR 5 REMOTE CONTROL

The ZR 5 is a discrete compact remote for controlling the applicable Zone
2 features of the M15 HD. Irrespective of the main room/zone settings, the
ZR 5 allows full separate control of the Zone 2 source selection among
other applicable features.
1
2
5
1 ON/OFF: Switch ON/OFF the Zone feature.
2 SOURCE [ 5/6 ]: Select the active input of the NAD M15 HD that will
be sent out to the corresponding rear panel ZONE 2 output port.
3 MUTE: Temporarily switch OFF or restore the Zone Volume level.
4 VOLUME [ 5/6 ]: Increase or decrease the loudness level of selected
Zone source. This is possible only if the VOLUME setting of ZONE 2 is set
to VARIABLE.
5 PRESET [ 3/4 ]: Step up or down between stored radio presets. This
control button is possible if the selected Zone is "TUNER" and the active
tuner section has stored presets. This control button is not applicable to
M15 HD.
6 The following CD Player Zone buttons can control a compatible CD
Player. The CD Player has to be powered ON and disc loaded.
SKIP [ 9 ] : Go to the beginning of a track/file or previous track/file.
SKIP [ 0 ]: Go to the next track/file.
[ 4 ]: Start playback.
NOTE
The ZR 5 remote control will only control Zone 2 applications. Zone 3
and Zone 4 could be configured and managed at the appropriate Zone
OSD menu using the corresponding keys on the HTRM remote control.
The HTRM's "CUSTOM" device is also defaulted to Zone 2 remote control
codes.
3
4
6