Punch-Through (Pun Thr) - NAD M15 HD Owner's Manual

OPERATION
USING THE HTRM REMOTE CONTROL
3 Press [ENTER].
4 Press [MENU] button of HTRM – [MENU] button of the HTRM is where
the corresponding [MENU] function key of the TV remote control will be
learned.
5 Press and hold the corresponding [MENU] button of the TV remote
control until "Success" is shown in the display. (Refer also to "MODE"
discussion below).
6 "Success" will be shown in the display if the [MENU] function key is
successfully "learned. " You can now release the [MENU] button of the TV
remote control.
7 Wait until "Success" is extinguished from the display to complete the
process.
NOTE
"Failed" will be shown in the lower line display if the "learning" of the
desired function key is unsuccessful. Repeat Step 3 – 7 again until
"learning" of the desired key is successful.
MODE
There are three modes on how a function key can be learned. Press and hold
[TUNER (10+/SETUP)] and [ENTER] buttons. Use [ 6 ] to scroll to "Learn". Press
[ENTER] and then [ 6 ] to scroll to "Mode". The following are the three modes:
Normal: This is the regular learning mode. A function key is learned until
"Success" is shown in the display. The example above is at "Normal" learn mode.
2 Pass: Some remote controls use an IR (infrared) "toggle bit". This means
that if you press the same key twice in a row, the IR signal toggles between
two different variations of the same command.
36
At "2 Pass" mode, step 5 and onwards of the above example would be as
follows (the same Steps 1 – 4 of the above example applies)
5 Press and hold the corresponding [MENU] button of the TV remote
control.
6 Release [MENU] button.
7 "Pass 2" means that you have to press [MENU] button again. Press until
"Success" is shown in the display.
8 "Success" will be shown in the display if the [MENU] function key is
successfully "learned. " You can now release the [MENU] button of the TV
remote control.
9 Wait until "Success" is extinguished from the display to complete the
process.
Narrow: Some remote controls use very narrow pulses of IR. If you cannot
get your remote to work using the normal or 2 Pass modes, you may want
to try this mode. The same example above for "Normal" mode applies to
"Narrow" mode.

PUNCH-THROUGH (Pun Thr)

The HTRM's "Punch through" function allows you to retain a function key
from one DEVICE SELECTOR "page" to another.
Example: Punch-through "SURR MODE" key to the "DVD" page.
1 Press [DVD] in the DEVICE SELECTOR page.
2 Press and hold [TUNER (10+/SETUP)] and [ENTER] buttons. Use [ 6 ] to
scroll to "Pun Thr".
3 Press [ENTER].
4 Press [SURR MODE] button – this is the function key that will be
punched through.