Table of Contents
Advertisement
CHORUS
In this effect, a slightly detuned sound is added to the
original sound to add depth and breadth.
Parameter/
Explanation
Range
MODE
Selection for the chorus mode.
This chorus effect outputs the same sound
MONO
from both L channel and R channel.
This is a stereo chorus effect that adds dif-
STEREO1
ferent chorus sounds to L channel and R
channel.
This stereo chorus uses spatial synthesis,
with the direct sound output in the L
STEREO2
channel and the effect sound output in the
R channel.
RATE
0–100
Adjusts the rate of the chorus effect.
DEPTH
Adjusts the depth of the chorus effect.
0–100
To use it for doubling effect, set the
value to 0.
PRE DELAY
Adjusts the time needed for the effect
sound to be output after the direct sound
has been output.
0.0ms–40.0ms
By setting a longer pre delay time, you can
obtain an effect that sounds like more than
one sound is being played at the same time
(doubling effect).
E.LEVEL (Effect Level)
0–100
Adjusts the volume of the effect sound.
DBL DELAY (Doubling Delay)
By adding a slightly time-delayed sound to the direct
sound, this produces the impression that multiple sources
are sounding together (a "doubling" effect). Best results will
be achieved when stereo recording.
Parameter/
Explanation
Range
DLY TME (Delay Time)
This parameter adjusts the delay time (i.e.,
0.5–50.0 ms
the interval for which sound is delayed).
SEPARATION
Adjusts the diffusion. The panning of the
direct sound and effect sound can be
-50–+50
spread to left and right.
This effect is obtained with stereo record-
ing (using two tracks).
E.LEVEL (Effect Level)
0–120
This adjusts the volume of the delay sound.
Using Insert Effects
79
Advertisement
Table of Contents
