Table of Contents
Advertisement
Using Insert Effects
SITAR SIM (Sitar Simulator)
This simulates the sound of the sitar.
Parameter/
Explanation
Range
TONE
This adjusts the tone.
-50–+50
The high end is boosted as the value in-
creases.
SENS (Sensitivity)
Adjusts the sensitivity of the sitar.
When it is set to a lower value, no effect of
the sitar is obtained with weaker picking,
0–100
while stronger picking produces the effect.
When it is set to a higher value, the effect of
the sitar can be obtained whether the pick-
ing is weak or strong.
DEPTH
0–100
This adjusts the amount of effect applied.
RESONANCE
This adjusts the undulation of the reso-
0–100
nance.
BUZZ
Adjusts the amount of characteristic buzz
0–100
produced by the "buzz bridge" when the
strings make contact with it.
E.LEVEL (Effect Level)
0–100
Adjust the volume of the sitar sound.
D.LEVEL (Direct Level)
0–100
Adjust the volume of the direct sound.
OCTAVE
This adds a note one octave lower, creating a richer sound.
Because of the need to analyze the pitch, chords (two or
more sounds played simultaneously) cannot be played.
Parameter/
Explanation
Range
OCT LEVEL (Octave Level)
Adjusts the volume of the sound one octave
0–100
below.
D.LEVEL (Direct Level)
0–100
Adjusts the volume of the direct sound.
76
P SHIFTER
This effect changes the pitch of the original sound (up or
down) within a range of two octaves.
Parameter/
Explanation
Range
TYPE
Selects either manual pitch shifter "MANUAL" or pedal
pitch shifter "PEDAL."
MANUAL
This is a simple pitch shifter.
The effect will function as a pedal pitch
shifter.
The effect of the wah pedal can be obtained
PEDAL
by operating the Expression pedal.
For a detailed explanation, see "Using an
Expression Pedal" (p. 133).
MODE
Selection for the pitch shifter mode.
FAST,
The response is slower in the order of
MEDIUM ,
FAST, MEDIUM and SLOW, but the mod-
SLOW
ulation is lessened in the same order.
PITCH
Adjusts the amount of pitch shift (the
-24–+24
amount of interval) in semitone steps.
FINE
Make fine adjustments to the interval.
-50–+50
The amount of the change in the Fine 100 is
equivalent to that of the Pitch 1.
PRE DELAY
Adjusts the time from when the direct
sound is heard until the pitch shifted
0ms–300ms
sounds are inputted. Normally you can
leave this set at 0ms.
FBK (Feedback)
Adjusts the feedback amount of the pitch
0–100
shift sound.
LEVEL
0–100
Adjusts the volume of the pitch shifter
D.LEVEL (Direct Level)
0–100
Adjusts the volume of the direct sound.
Advertisement
Table of Contents
