Main Menu - SMART Audio System navigation/multimedia Supplement Manual

Voice control system
62
light blue speech bubbles. An active
audio source is muted.
You can start the voice control system in
this way from any navigation display.
The commands depend on the respective
navigation mode submenu. Almost all the
functions available for manual input are
also available with the voice control sys-
tem.
Switching the voice control system off
X
Say "Cancel".
The voice control system is switched off.
or
X
Press a menu option.
The voice control system is switched off
and the selected function is carried out.
i
The voice control system is switched off
automatically at the end of an input
sequence (e.g. when starting route guid-
ance).
Adjusting the volume
X
Start the dialogue.
X
Say a command, e.g. "Main menu".
X
Set the volume by turning cVd the con-
trol knob.
The volume increases or decreases dur-
ing the voice output.
Controls
Please bear the following in mind
G
WARNING
The navigation system cannot take the pre-
vailing traffic situation into account or
recognise any dangers or obstacles. You
must therefore be constantly aware of the
prevailing road and traffic conditions so
that you can recognise any dangers and
react to them.
The route guidance only provides recom-
mendations. You must always comply with
the national road traffic regulations and
adapt your driving style to the prevailing
conditions. You could otherwise become
involved in an accident in which you or
others could be injured.
General commands
Voice commands are marked by ? in this
manual. The following voice controls are
always available.
? Back
R
The previous menu is shown.
? Cancel
R
The voice control system is switched off.
? Help
R
The voice control system starts the help
function. You can use the "Help" command
to have all of the basic commands read
out.

? Main menu

R
The navigation main menu is displayed.
Announcement of the available commands
In some menus, e.g. the navigation main
Y
menu ( page 33), the voice control system
informs you of the available commands.
Voice control system voice outputs have the
^ symbol in this manual.