Using Rinse Agent Dispenser - Whirlpool 8500 SERIES Use & Care Manual

Using Rinse Agent Dispenser
Rinse agent dispenser
Keep the rinse agent dispenser filled with a liquid
rinse agent such as Jet-Dry.% A rinse agent
greatly improves the drying of dishes by
helping water flow off of them during the
last rinse. A rinse agent also keeps water from
forming droplets and drying as spots. A small
amount of rinse agent is automatically released
into the rinse water during the final rinse of
each cycle.
For best drying results, check the
dispenser periodically to see if it needs
refilling. The center of the Fill Indicator Cap
will be clear when dispenser needs refilling. An
"E" will also be visible inside the dispenser when
the cap is removed and the dispenser is empty.
The dispenser will hold 6 ounces of rinse agent.
Under normal conditions, this will last about 3
months. You do not have to wait until the dispenser
is empty to refill it, but do not overfill it.
Make sure the dishwasher door IS fully open
when filling the dispenser. Do not fill past the
smallest opening in the lower pat-t of the dispenser.
If you overfill, excess rinse agent can come out.
This will not harm the dishwasher, but could cause
over-sudsing. Clean up any spilled rinse agent
with a damp cloth. Replace the Fill Indicator Cap
and keep it lightly closed.
NOTE: Because your dishwasher is designed to
use a liquid rinse agent, you do not need to use a
solid or bar-type rinse agent.
@Registered Trademark of
Benckiser Consumer Products, Inc
13