Using Rinse Agent Dispenser - Whirlpool DU4000XY Use & Care Manual

Using Rinse Agent Dispenser
Rinse agent dispenser
Keep Ihe rinse agenl dispenser filled with a liqurd
rinse agenl such as Jel-Dry." A rinse agent
greatly improves the drying of dishes by
helping water flow off of them during the
last rinse. A rinse agent also keeps water from
forming droplets and drying as spots. A small
amount of rinse agent is automalically released
inlo Ihe rinse water during the final rinse of each
cycle.
For best drying results, check the
dispenser periodically to see if it needs
refilling.
To check dispenser
The center of the Fill lndicalor Cap will be clear
when dispenser needs relilling. An "E" will also
be visible inside the dispenser when the cap is
removed and the dispenser is empty.
To fill dispenser
The dispenser will hold 6 ounces of rinse agent,
Under normal conditions, this will last about 3
months. You do nol have to wait until the dispenser
is empty to refill it, but do not overfill it.
Make sure Ihe dishwasher door is fully open
before removing the Fill Indicator Cap. Do not fill
past Ihe smallest opening in the lower part of the
dispenser. If you overfill, excess rinse agent can
come out. This will not harm Ihe dishwasher, but
could cause over-sudsing. Clean up any spilled
rinse agent with a damp cloth. Replace Ihe Fill
Indicator Cap and keep it tightly closed.
NOTE: Because your dishwasher is designed to
use a liquid rinse agent, you do not need to use a
solid or bar-type rinse agent.
Keep rinse agent
dispenser filled for
R Regislered Trademark of Benckrser Consumer Products. Inc