Table of Contents
Advertisement
Connecting A Portable Dishwasher
A special adapter must be installed on the faucet
before the dishwasher can be connected.
Complete instructions and the adapter are packed
with your dishwasher.
When moving your dishwasher, make sure the
door is latched. Hold the dishwasher at the top
front corners.
Before starting
1. Run water at faucet until it is hot. Turn it off.
2. Pull hoses out of their storage compartment
on
the back.
3. Pull down on the locking collar while lifting the
hose connector onto the faucet adapter.
4. When the connector snaps into place, release
the locking collar.
HoA connector
5. Turn the hot water on slowly until it is all the
way on.
6. Plug in power supply cord.
7. See pages 3 and 4 to start the dishwasher.
While dishwasher
is running
You can draw water from the faucet while the dish-
washer is connected. Do not draw water while the
dishwasher is filling or while water is being
pumped out. (This helps prevent a low fill when
dishwasher is filling, or mixing drain water with
fresh water.)
1. Press red button on hose connector to get the
water you want. (The faucet is set on hot. Adjust
faucet for the water you want.)
2. Be sure you return
cold water to off, and
that hot water is full on.
When cycle is finished
1. Turn hot water off. (This can be done after the
last rinse.)
2. Press the red button on the connector to release
the water pressure.
3. Lift slightly on the hose connector while pulling
down the locking collar. Pull down on the
connector.
4. Empty any remaining water from the connector.
5. Unplug power supply cord and return to storage
compartment.
6. Return hoses to storage compartment.
:4
Advertisement
Table of Contents
