Control Board Settings - Grindmaster Grind’n Brew-10 Operation And Instruction Manual

Control Board Settings

J1 Jumper should remain on pin 1 & 2
J2 Jumper Controls
- No pin connected with jumper - No minimum brewing temperature.
- Jumper connecting 2 & 3 - Low temperature no brew. The brewing cycle will wait until
temperature of water (factory setting) is ready before continuing.
- Jumper connecting 1 & 2 - Disables thermistor. Unit must use a thermostat to operate
properly (not normally used).
Page 9
(Refer to Figure H)
Figure H
Grind'n Brew Coffee Systems™