Care And Maintenance - Emotiva Pro Stealth DC-1 User Manual

Stealth DC-1 Stereo D/A Converter - Operator's Manual

Care and Maintenance

periodic maintenance
Your Emotiva Pro Stealth DC-1 requires no periodic maintenance or calibration.
Cleaning the Cabinet and front panel
• The cabinet of the DC-1 should normally be cleaned with a rag dampened with plain
water. DO NOT spray water directly onto or into the DC-1, or into the connectors or
volume control and encoder, and DO NOT use abrasive or chemical cleaners. Gently
dry the surface with a clean soft rag after cleaning.
• If necessary, use a mild detergent, wipe the surface with a rag dampened with plain
water to rinse it, then gently dry the surface with a clean soft rag.
• If something nasty does get on the sides or top of your DC-1, use a rag dampened
with a weak solution of dish detergent or other mild cleaning liquid, followed by a
rag dampened with plain water, and dry with a clean rag.
• If it appears that liquid may have spilled into the vents, plese disconnect power to
the Stealth DC-1 immediately and contact Emotiva Pro Technical Support.
Changing the fuse
If the fuse blows, ALWAYS REPLACE IT WITH ONE OF THE SAME SIZE,
•
RATING, AND TYPE; NEVER USE A FUSE OF HIGHER RATING.
If the fuse blows repeatedly CONTACT EMOTIVA PRO TECHNICAL SUPPORT.
•
(If there is any doubt, first verify that your AC power source is the correct voltage.)
• The fuse is located on the AC inlet filter board (which is attached to the IEC power
cord receptacle). Replace the fuse with one of the same size, rating, and type (be
sure to press firmly so it locks into place).
Instructions for opening and closing the DC-1 case can be found in the Hardware
Configuration section (in the section entitled Configuring the headphone frequency
response).
Page 18