Emotiva Pro Stealth DC-1 User Manual page 18

Stealth DC-1 Stereo D/A Converter - Operator's Manual
To change the headphone bass boost jumper setting, first turn Off your Stealth DC-1
and disconnect the power cable.
Remove the six screws securing the top cover, then remove the cover.
(The cover hooks under the front panel on the front edge, so lift it up from the back
edge and tilt it forward to remove it.)
Using tweezers or long nosed pliers, carefully move the two jumpers shown into the
correct position. (Nearer the front panel selects a true flat response; nearer the rear
panel selects the bass boost.)
Note: The bass boost, which is approximately 2 dB at 20 hz, affects oNly the
headphone outputs.
Replace the cover and the six screws securing the it.
FRONT
Headphone
Amp EQ
Bass Boost
Flat Jumper
Enabled
Settings
Page 14