Emotiva Pro Stealth DC-1 User Manual page 12

Stealth DC-1 Stereo D/A Converter - Operator's Manual
The Stealth DC-1 Stereo 24-192 Balanced DAC (Front Panel)
INPUT/MENU VOLUME/STANDBY
1 2 3 4
1. Input / Menu encoder knob
In normal operation, rotating this knob selects between connected inputs.
As the knob is rotated, the currently selected input and current Volume setting are
displayed in the OLED display. After a few seconds the Volume display changes to show
the current sample rate of the selected input.
Note: Even when the AsRC (asynchronous sample rate converter) is engaged,
the stealth DC-1 always delivers the input to the DAC at its original sample
rate - so you always get an accurate rendition of your source material.
Pressing this knob enters the Setup Menu.
See the section entitled Setup Menu for more details.
2. Display (high visibility blue OLED)
In normal operation, this display shows the selected input and the sample rate of the
input signal. (If there is no input signal, then the current Volume setting is displayed.)
The display can be dimmed (in five steps). When the Input / Menu encoder or the
Volume / Standby knobs are in use, the display will temporarily switch to show menu
entries or status (and temporarily return to full brightness).
3. Headphone jacks (2)
Both headphone jacks are active at all times. The main outputs are disabled when a
headphone is plugged into either headphone jack.
Note: The headphone level on the stealth DC-1 is intelligent. When no
headphone is plugged in, the Volume knob controls the main output level;
when a headphone is plugged in, the Volume knob controls headphone level.
Each is stored independently, and the DC-1 will return to its previously
set main or headphone output level when a headphone is plugged in or
unplugged.
Page 8