Fitting The Proximity Switch - DURKOPP ADLER 888 Instruction Manual

4.6

Fitting the proximity switch

2 1 4 3 5
–
The proximity switch (1) is mounted to certain positioning motors
(drives) only. In that case it is part of the drive supply.
–
Slide the proximity switch (1) in the arrow (2) direction on the hand
wheel shaft so that the carrier pin (3) fits in the proximity switch
groove.
–
Attach the proximity switch with two screws (4).
–
Remove the back cover and pull the proximity switch cable (5)
through according to the picture.
–
Attach the cable with a clip (6).
6
15