Adding Cards - Dell Dimension 4400 Manual

Adding Cards

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
1. Shut down the computer.
2. Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3. Disconnect the power cable from your computer, and then press the power button to ground the system board.
4. Open the computer cover.
5. To raise the securing lever, press the tab until it is free from the latch and then lift the lever.
6. Insert the card into the connector.
7. Ensure that the card is fully seated in the connector.
"Safety Instructions."
opening the cover.