Igmp Member Port Table - Dell PowerConnect 5212 System User's Manual

Console(config)#exit
Console#show ip igmp snooping
Service status: Enabled
Querier status: Enabled
Query count: 10
Query interval: 100 sec
Query max response time: 20 sec
Router port expire time: 300 sec
IGMP snooping version: Version 1
Console#

IGMP Member Port Table

You can use the IGMP Member Port Table page to assign ports that are attached to hosts that are supposed to receive a specific multicast service.
The following options are available:
VLAN ID — Specifies the VLAN ID
l
Multicast IP Address — Allows you to select or add the IP address for a specific multicast service
l
New IP Address — Specifies the IP address of a new multicast service
l
Port/Trunk Toggle Buttons — Allows you to select ports or trunks to receive the specified multicast service by toggling the value of the port/trunk
l
button:
'S' — Statically sets a port or trunk as a group member of the multicast service
¡
'D' — Indicates that a port or trunk has been dynamically set as a group member of the multicast service
¡
'BLANK' — Indicates that the port or trunk is not a group member of the multicast service
¡
NOTICE: You must set at least one port or trunk as a static member before you add a new multicast IP address. If you remove all static members from
a group, the IP address is also removed.
To save any changes you make in this page, click Apply Changes. If you don't want to save the changes, click Refresh.