Replacing Memory Module(S) - Dell XPS 625 Service Manual

Back to Contents Page
Replacing Memory Module(s)
Dell™ XPS™ 625 Service Manual
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
1. Follow the procedures in Before You
2. Remove the computer cover (see
3. Locate the memory modules on the system board (see
4. Press out the securing clip at each end of the memory module connector.
1 securing clip 2 memory module connector
5. Grasp the memory module and pull it upwards.
If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from the connector.
CAUTION: Do not install ECC memory modules.
6. To install memory module(s), align the notch on the bottom of the module with the tab in the connector.
1 cutouts (2)
3 notch
CAUTION: To avoid damage to the memory module, press the module straight down into the connector while you apply equal force to each end of
the module.
7. Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
8. Replace the computer cover (see
Begin.
Replacing the Computer Cover).
System Board
2 memory module
4 tab
Replacing the Computer Cover).
Components).