•
Place heat tents over tube burners by inserting tabs into slots in front of firebox. Opposite ends of heat tents rest on pins in back of
13
firebox.
NOTE: There is no heat tent over sear burner.
•
Place cooking grates onto grate rests.
14
•
Insert ends of Warming Rack pivot wire into holes in sides of gril lid. Insert ends of Warming Rack leg wire into holes in sides of
firebox.
NOTE: Pivot and leg wires, running side-to-side, should be under wires running front-to-back. If pivot and leg wires are on top,
Warming Rack is installed upside-down.
•
Unscrew ignitor cap and place AA battery into ignitor slot with positive end (+) facing outward. Screw ignitor cap onto ignitor.
Pivot Wire
26
Sear Burner
-
+
+
–
AA Battery
Pin
Warming Rack
Leg Wire
Cooking Grate