Brother MFC-8420 User Manual page 390
Hide thumbs
Also See for MFC-8420:
- User manual (427 pages) ,
- Service manual (353 pages) ,
- Quick setup manual (57 pages)
Table of Contents
Advertisement
DIFFICULTY
Print Quality Difficulties
Printed pages are curled.
Printed pages are smeared.
Printouts are too light.
Network Difficulties
I cannot print over the Network
TROUBLESHOOTING AND ROUTINE MAINTENANCE 22 - 16
SUGGESTIONS
Thin or thick paper below the standard can cause this problem. Make
sure you select the Paper Type that suits the media type you use. (See
Setting the Paper Type on page 4-6 and Media Type on page 12-4.)
The Paper Type setting may be incorrect for the type of print media you
are using—OR—The print media may be too thick or have a rough
surface. (See Setting the Paper Type on page 4-6 and Media Type on
page 12-4.)
Set Toner Save mode to off in the Advance tab in the printer driver. (See
Toner Save Mode on page 12-6.)
Make sure that your MFC is powered on and is On Line and in Ready
mode. Press the Test switch. Then the current settings of the NC-9100h
are printed.Verify that the cabling and Network connections are good. If
possible, try connecting the MFC to a different port on your hub using a
different cable. Check to see if there is any LED activity. The NC-9100h
has a two color LED for diagnosing problems.
Advertisement
Table of Contents
