Insertion And Removal Steps; Insertion; Removal; En Led - Cisco VG350 Installation Manual

EN LED

Insertion and Removal Steps

This section describes the sequence of steps when inserting or removing a DWSM. OIR can only be done
on one service module at a time. It only supports the same service module type. If you remove an
SM-D-72FXS, only another SM-D-72FXS can be inserted.

Insertion

The following steps show how to insert a service module.
1.
2.
Note There are about 72 or 48 messages being displayed so it may take some time for the message to appear.
Estimated waiting time is approximately 2 minutes.
3.

Removal

The following steps show how to remove a service module.
1.
2.
3.
4.
EN LED
Each Service Module(SM) has an Enable LED that is mounted on the SM and visible through the
faceplate of the SM. The EN LED includes:
•
•
Cisco VG350 Voice Gateway Hardware Installation Guide
2-8
Insert the service module into the slot.
Make sure that the following message is displayed:
*Apr 19 00:14:19.177: %LINK-3-UPDOWN: Interface Foreign Exchange Station x/y/z,
changed state to up
Use the following command to verify the voice ports after insertion.
show voice port summary
Ensure there is no active call on the service module that you want to remove.
Use the following command to find any active call in the system:
show voice call status
Use the following command to proceed:
hw-module sm x oir-stop
where x is the slot number of the Service Module
Wait until the following message is displayed:
SM Hardware slot 2 can be removed
Remove the service module from its slot.
Green / Amber Dual Color LED
Defaults to OFF / ON power up
Chapter 2 Cisco Double-Wide High Density Analog Service Modules
OL-25970-01