Table of Contents
Advertisement
2.7 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose
pin1 and pin2 are "Short" when jumper cap
is placed on these 2 pins.
ME Recovery Jumper
(3-pin ME_RECOVERY1)
(see p.22, 25, 28, 31)
PSU Jumper
(9-pin PSU Jumper)
(see p.22, 25, 28, 31)
PSU Jumper
(9-pin PSU Jumper)
(see p.22, 25, 28, 31)
-12V_SW Jumper
(3-pin -12V_SW Jumper)
(see p.22, 25, 28, 31)
1
1
1
1
1
1
51
1-2:
Default
2-3:
ME recovery mode
1-2:
PSU_SMBus loads the data
via PCH chip
2-3:
PSU_SMBus loads the data
via BMC chip (Default)
1-2:
PSU_SMBus loads the data
via PCH chip
2-3:
PSU_SMBus loads the data
via BMC chip (Default)
1-2:
The motherboard provides
-12V signal
*Move the jumper cap to pins 1-2
when using a PSU without -12V signal
2-3:
The PSU provides -12V
signal (Default)
Advertisement
Table of Contents
