STEP 2: SURFACE BURNERS
To replace the nozzles of the surface burners, lift
up the burners and unscrew the nozzles shipped
with the range using a 7 mm {sochet wrench).
Replace nozzles using the conversion set supplied
with the range or by a Bertazzoni authorized
parts warehouse. Each nozzle has a number
indicating its flow diameter printed on the body.
Consult the table on page 20 for matching nozzles
to burners.
STEP 3: MAIN OVEN BURNER
To replace the nozzles of the main oven burner,
start by :
Remove the enamelled cavity base plate
Loosen and the screw V and pull out the burner
from the support being careful not to damage the
ignition plug and the thermocouple
Unscrew the nozzle R using a 7 mm. spanner and
replace it with the nozzle for the new type of gas
according to what is indicate in the table below
ATTENTION: pay extra attention to avoid damage
to the igniter and thermocouple.
Re‐install all the parts in revers sequence
16