Installation - Hitachi CDR-8130 Instruction Manual

Circuit Board
(9) ATAPI Interface Connector
ATAPI bus connection (40 pin)
(10) Power Supply Connector (DC Input)
For connecting the power supply cable.

INSTALLATION

WHAT YOU NEED
HARDWARE
- CD-ROM Drive
- Interface cable
- Mounting screws
HARDWARE OPTION
- Audio connecting cable
SOFTWARE
- CD-ROM device driver
NOTE
If you need a interface card or interface cable or CD-ROM device
driver, contact your dealer.
HARDWARE INSTALLATION
To install this CD-ROM drive in the host computer, refer to the instruction
manual of each host computer.
And to install the interface card in the host computer, refer to the instruction
manual of each host computer and each interface card.
6 4 2
3 1
5
Circuit Board
- Interface card
- Power supply cable
- Sound Card
7
Device is
(Default setting)
Master
Device is
OR
Slave
Cable
Select
4 3 2 1
+12V
GND
+5V