Hitachi CDR-8130 Instruction Manual
Hitachi CDR-8130 Instruction Manual

Hitachi CDR-8130 Instruction Manual

Hitachi instruction manual cd-rom drive cdr-8130

Advertisement

IMPORTANT
- Read all of these instructions carefully and understand
them before using your CD-ROM drive.
- Keep this instruction manual for future reference.
- If this CD-ROM drive changes ownership, be sure this
manual accompanies the CD-ROM drive.
IMPORTANT SAFEGUARD--------------------------------------- 4
CONTROLS AND FUNCTIONS---------------------------------- 6
INSTALLATION ------------------------------------------------------ 7
DRIVE OPERATION ------------------------------------------------ 8
EMERGENCY EJECT PROCEDURE -------------------------- 9
LENS CLEANING ---------------------------------------------------10
TROUBLESHOOTING---------------------------------------------10
MECHANICAL DIMENSIONS -----------------------------------11
SPECIFICATIONS--------------------------------------------------12
INSTRUCTION MANUAL
CD-ROM DRIVE
CDR-8130
MODEL
CONTENTS
READ AND KEEP THIS MANUAL
1

Advertisement

Table of Contents
loading

Summary of Contents for Hitachi CDR-8130

  • Page 1: Table Of Contents

    - If this CD-ROM drive changes ownership, be sure this manual accompanies the CD-ROM drive. IMPORTANT SAFEGUARD--------------------------------------- 4 CONTROLS AND FUNCTIONS---------------------------------- 6 INSTALLATION ------------------------------------------------------ 7 DRIVE OPERATION ------------------------------------------------ 8 EMERGENCY EJECT PROCEDURE -------------------------- 9 LENS CLEANING ---------------------------------------------------10 TROUBLESHOOTING---------------------------------------------10 MECHANICAL DIMENSIONS -----------------------------------11 SPECIFICATIONS--------------------------------------------------12 READ AND KEEP THIS MANUAL CDR-8130 CONTENTS...
  • Page 2 For USA Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
  • Page 3 CAUTION INVISIBLE LASER RADIATION WHEN OPEN. DO NOT STARE INTO BEAM OR VIEW DIRECTLY WITH OPTICAL INSTRUMENTS. VORSICHT UNSICHTBARE LASERSTRAHLUNG, WENN ABDECKUNG GEÖFFNET. NICHT IN DEN STRAHL BLICKEN AUCH NICHT MIT OPTISCHEN INSTRUMENTEN. ATTENTION RADIATION DU FAISCEAU LASÉR INVISIBLE EN CAS D'OUVERTURE EVITER TOUTE EXPOSITION AUX RAYONS.
  • Page 4: Important Safeguard

    IMPORTANT SAFEGUARDS SAFETY POINTS YOU SHOULD KNOW ABOUT YOUR EQUIPMENT READ ALL INSTRUCTIONS. SAVE THESE INSTRUCTIONS FOR LATER USE. FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE PRODUCT. PRECAUTIONS FOR SAFETY Power source -This CD-ROM Drive should be operated from the type of power source indicated on the marked label.
  • Page 5 - In a place where an operation temperature reaches beyond the specified temperature 40C - High humidity locations - In a location subject to extreme changes of temperature and humidity - In a room where dust density higher than 0.1 mg/m - In a room that has air conditioning with humidity control which may scatter calcium combinations and other powdered substances - In a room containing exhaust gas fumes such as exhaust gas from gasoline or...
  • Page 6: Controls And Functions

    CONTROLS AND FUNCTIONS Front Panel (1) LOADING/UNLOADING/BUSY Indicator Indicator blinks green only when the Disc Tray is being opened or closed, or when the CD-ROM drive is accessing data. (2) Disc Tray When the power of the CD-ROM Drive is turned off, the Disc Tray can not be opened and closed.
  • Page 7: Installation

    Circuit Board (9) ATAPI Interface Connector ATAPI bus connection (40 pin) (10) Power Supply Connector (DC Input) For connecting the power supply cable. INSTALLATION WHAT YOU NEED HARDWARE - CD-ROM Drive - Interface cable - Mounting screws HARDWARE OPTION - Audio connecting cable SOFTWARE - CD-ROM device driver NOTE...
  • Page 8: Drive Operation

    Install the CD-ROM Drive following general installation procedure shown below. 1. Check the Device Configuration Jumper settings of the CD-ROM Drive such as Master, Slave, CSEL. (See page 6) 2. Turn off the host computer and unplug the power supply cable of the host computer.
  • Page 9: Emergency Eject Procedure

    120 mm Disc Disc label side Disc Tray IMPORTANT - Do not press the OPEN/CLOSE button while the host computer is accessing the disc. It may caused an error. - When not using the CD-ROM Drive, keep the Disc Tray closed. It will prevent the entry of the dust and dirt, and reduce the requirements for disc and lens cleaning CAUTION...
  • Page 10: Lens Cleaning

    CAUTION Do not use a breakable bar. A broken bar inside the CD-ROM Drive may cause a malfunction. Lens Cleaning A commercially available "Laser Lens Cleaning Disc" may be used to clean up the pick-up lens of the CD-ROM Drive. Use the Compact Disc Laser Lens Cleaner LLC-1.
  • Page 11: Mechanical Dimensions

    Symptoms Possible causes The CD-ROM 1.You place the disc up-side Drive does not down in the Disc Tray. operate even when 2. The disc is dirty. a disc is loaded. 3. The pick-up lens is dirty. 4.The disc is scratched or warped.
  • Page 12: Specifications

    Design and specifications are subject to change without prior notice. Hitachi has done everything possible to prevent the failure of the CDR-8130. However, it is not absolutely free from failure. In case it should fail, Hitachi is not responsible for the results.

Table of Contents

Save PDF