Restoring All The Recording Settings To Default (Full Auto); Using The Flash - Hitachi DZ-HS903A Instruction Manual

Press the confirmation button to
confirm, then MENU to end.
When the function is turned On,
" " appears in the LCD
monitor (p.42).
• The MIC. filter setting is
retained in memory even when
3
the power is turned off.
• If you set this function to
"On", it is recommended to set
the function to "Off" after
recording before turning off
the power unless you always
intend to use this function.
HDD RAM -RW (VR) -RW (VF)
Restoring all the
Recording Settings to
Default (Full Auto)
You can reset the following manually
adjusted recording settings to their
defaults with the press of a single
button.
Function
Focus
Exposure
BLC (Backlight)
Program AE
White Balance
EIS (Electronic
Image Stabilizer)
MIC. Filter
72
R CARD
+RW
Default See
Auto p.64
Auto p.66
Off p.67
Auto p.67
Auto p.68
On p.71
Off p.71
Setting the recording
settings to full auto
During record pause or recording,
press FULL AUTO.
"FULL AUTO" appears in the
1
LCD monitor for a while and the
settings are reset to their default
settings.
CARD

Using the Flash

As shutter speed will slow down
when still photos are recorded in dim
lighting, camera shake may easily
occur. We recommend you use a flash
in this case.
Normally, the flash fires
automatically depending on the
recording conditions (during Auto).
You can also set the flash to On
(always fires) or Off (does not fire).