Strong SRT 5425 User Manual page 26

Automatic Search
1. Press MENU on the remote control.
2. If Installation is not highlighted on the main menu, press
The Installation sub-menu appears.
3. If Auto Search is not highlighted on the sub-menu, press
The Auto window appears, and the search begins automatically. When the search is finished, a
channel that has been found will begin playing.
Manual Searching
NOTE: Automatic searching (described above) is suitable in most cases. You might use
manual searching if you have deleted a channel and now want to access it again. In this
case, you would just search for that particular channel.
1. Press MENU on the remote control.
2. If Installation is not highlighted on the main menu, press
The Installation sub-menu appears.
3. If Manual Search is not highlighted on the sub-menu, press
OK.
The Manual Search window appears.
or t
5. Press o select the Frequency what you wish to search.
6. Press AUDIO button (the green button) to add the Frequency what you wish to add .
TIP: To avoid a fruitless search, check the strength and quality of the signal beforehand.
These are shown by the Level and Quality bars at the bottom of the screen. Poor strength
or quality indicates that it may be difficult to scan for that channel or that the reception
might be too poor for you to comfortably watch the channel.
4. Press OK to begin scanning. When the search is finished, the channel will begin playing if it has
been found; otherwise the previous channel will reappear.
or until it is and then press OK.
or until it is and then press OK.
or until it is and then press OK.
or
CH CH
26
until it is and then press