Download Print this page

Kolcraft UNIVERSAL CAR SEAT CARRIER Instruction Sheet page 9

Universal car seat carrier
Hide thumbs Also See for UNIVERSAL CAR SEAT CARRIER:

Advertisement

TO ATTACH YOUR BRITAX
TO ATTACH YOUR COSCO
7
CARE
®
OR BABY SAFE
INFANT CAR SEAT / SAFETY 1ST
WARNING!
!
When using this product, to avoid serious injury
from falling or sliding out, infant must always be
secured in the Infant Car Seat with the Car Seat
harness. Refer to Infant Car Seat Instructions for
proper adjustment.
Step 1.
Adjust Adjustment Bar to
position "B" by pushing both red
buttons and rotating bar until it
clicks into place (Figure A).
Step 2.
With one hand, grasp the
Infant Car Seat handle (in its upright,
carrying position).
•With your other hand, grasp Infant
Car Seat near baby's feet. Gently
position the Infant Car Seat above
Carrier so the baby faces the handle.
Step 3
. Place front portion of the
Infant Car Seat so that the cart catch
fits onto Stationary Bar (Figure B).
Step 4.
Gently place front
portion of Infant Car Seat onto
stationary bar (Figure C).
NOTE:
Your Infant Car Seat should
be secured to the Stationary Bar.
Step 5.
Secure Car Seat to Carrier
by feeding Restraint Straps through
Infant Car Seat belt slots and buckle.
Tighten Restraint Straps (Figure C).
Step 6.
Make sure Infant Car Seat
is secure. Test Infant Car Seat
installation by moving it in all
directions to ensure a tight fit to
Carrier.
NOTE:
Your Infant Car Seat may
have a level indicator. It is not
necessary for use with this carrier
and the indicator may fall outside the
recommended area. The level
indicator is for use while the Infant
Car Seat is in an automobile.
Removing Car Seat
Step 7.
Unbuckle Restraint Straps
and remove them from Car Seat belt
slots.
Step 8.
With one hand grasp the
Infant Car Seat handle (in its upright,
carrying position).
•With your other hand, pull back
shopping cart lever on Adjustment Bar.
Pull up on the front portion of Infant
Car Seat and remove (Figure D).
®
HANDLE WITH
®
DESIGNER / OPUS 35
INFANT CAR SEAT
®
DESIGNER:
B
B
A
C
fig. A
fig. B
Adjustment Bar
Barra de Ajuste
3
5
fig. C
fig. D
Shopping Cart Lever
Palanca para el carro de mercaderías
PARA CONECTAR EL ASIENTO INFANTIL COSCO
DESIGNER / OPUS 35 / SAFETY 1ST
¡ADVERTENCIA!
!
Al usar este producto, evite daños serios causados
por caídas o al deslizarse del asiento. El niño debe
estar asegurado en el asiento. Use siempre el
cinturón. Consulte las instrucciones del asiento
de bebé para auto para ajustario adecuadamente.
Paso 1.
la posición "B" empujando ambos
botones rojos y girando la barra
(Figura A).
Paso 2.
Adjustment Bar
mango del asiento infantil (en su
Barra de Ajuste
posición vertical de acarreo).
•Con la otra mano, agarre el asiento
infantil cerca de los pies. Ponga el
asiento cuidadosamente sobre el
porta asiento con la cara del niño
hacia el mango.
Paso 3.
del asiento infantil de tal modo que el
gancho del carro esté sobre la barra
estacionaria (Figura B).
Paso 4.
delantera del asiento con la barra fija
(Figura C).
NOTA:
Stationary Bar
estar fijado a la barra estacionaria.
Barra Estacionaria
Paso 5.
Restraint Straps
porta asiento pasando las cintas de
Cinta de Seguridad
seguridad por la hebilla y el broche
del cinturón de seguridad del carro.
Aprietelas (Figura C).
Paso 6.
asiento de bebé para el auto esté bien
sujetado. Pruebe la instalación en para
asegurar que el asiento esté fijo al
porta asiento en todas direcciones.
NOTA:
bebé para el auto tenga un indicador
de nivel. No es necesario usarlo con
esta el asiento portatil y el indicador
4
puede quedar fuera de la zona
recomendada. El indicador de nivel es
Stationary Bar
para usar mientras el asiento de bebé
Barra Estacionaria
para el auto esté en un automóvil.
Para sacar el asiento infantil
Paso 7.
seguridad y sáquelas de las hebillas del
cinturón.
Paso 8.
mango del asiento infantil (en su
posición vertical de acarreo).
•Con la otra mano, agarre el asiento
infantil cerca de los pies. Jale con
cuidado por la parte delantera del
asiento y levantelo (Figura D).
9
®
®
DESIGNER:
Ajuste la barra de ajuste a
Con una mano agarre el
Coloque la parte delantera
Ponga con cuidado la parte
El asiento infantil debe
Asegure el asiento al
Asegúrese de que el
Puede que el asiento de
Desabroche las cintas de
Con una mano agarre el
S38-R5 12/02

Advertisement

loading