Download Print this page

Kolcraft UNIVERSAL CAR SEAT CARRIER Instruction Sheet page 12

Universal car seat carrier
Hide thumbs Also See for UNIVERSAL CAR SEAT CARRIER:

Advertisement

TO ATTACH YOUR BRITAX
TO ATTACH YOUR GRACO
10
CARE
®
OR BABY SAFE
RIDE SERIES INFANT CAR SEAT:
WARNING!
!
When using this product, to avoid serious injury
from falling or sliding out, infant must always be
secured in the Infant Car Seat with the Car Seat
harness. Refer to Infant Car Seat Instructions for
proper adjustment.
Step 1.
Adjust Adjustment Bar to
position "B" by pushing both red
buttons and rotating bar until it clicks
into place. (Figure A)
Step 2.
•With one hand, grasp the Infant Car
Seat handle (in its upright, carrying
position).
•With your other hand, grasp Infant Car
Seat near baby's feet. Gently position
the Infant Car Seat above Carrier so the
baby faces the handle.
Step 3.
Place rear portion of the
Infant Car Seat on top of Adjustment
Bar as shown. (Figure B)
NOTE: Your Infant Car Seat shopping
cart lever must be secured to the
Adjustment Bar.
Step 4.
Gently place front portion
of Infant Car Seat onto stationary bar.
(Figure B)
Step 5.
Secure Car Seat to Carrier
by feeding Restraint Straps through
Infant Car Seat belt slots and buckle.
Tighten Restraint Straps. (Figure B)
Step 6.
Make sure Infant Car Seat is
secure. Test Infant Car Seat installation by
moving it in all directions to ensure a tight
fit to Carrier.
NOTE: Your Infant Car Seat may have a
level indicator. It is not necessary for use
with this carrier and the indicator may fall
outside the recommended area. The level
indicator is for use while the Infant Car Seat
is in an automobile.
Removing Car Seat
Step 7.
Unbuckle Restraint Straps
and remove them from Car Seat belt
slots.
Step 8.
•With one hand grasp the Infant Car
Seat handle (in its upright, carrying
position).
•With your other hand, pull back
shopping cart lever on Adjustment Bar.
Pull up on the front portion of Infant
Car Seat and remove. (Figure C)
®
HANDLE WITH
®
SNUG
INFANT CAR SEAT
B
B
C
fig. A
Adjustment Bar
Barra de Ajuste
3
5
fig. B
fig. C
Palanca para el carro de mercaderías
PARA INSTALAR SU ASIENTO INFANTIL
GRACO
®
SNUG RIDE SERIES:
¡ADVERTENCIA!
!
Al usar este producto, evite daños serios causados por
caídas o al deslizarse del asiento. El niño debe estar
asegurado en el asiento. Use siempre el cinturón.
Consulte las instrucciones del asiento de bebé para auto
para ajustario adecuadamente.
Adjustment Bar
Barra de Ajuste
A
Restraint Straps
Cinta de Seguridad
4
Stationary Bar
Barra Estacionaria
Shopping Cart Lever
12
Paso 1.
Ajuste la barra de ajuste a la
posición "B" empujando ambos
botones rojos y girando la barra.
(Figura A)
Paso 2.
•Con una mano agarre el mango del
asiento infantil (en su posición vertical
de acarreo).
•Con la otra mano, agarre el asiento
infantil cerca de los pies. Ponga el
asiento cuidadosamente sobre el porta
asiento con la cara del niño hacia el
mango.
Paso 3.
Coloque la parte
posterior del Asiento Infantil encima
de la Barra de Ajuste, como lo
muestra el dibujo. (Figura B)
NOTA: La palanca del carro para
mercado del asiento de bebé, debe
estar asegurada a la barra de ajuste.
Paso 4.
Ponga con cuidado la parte
delantera del asiento con la barra fija.
(Figura B)
Paso 5.
Asegure el asiento al porta
asiento pasando las cintas de seguridad
por la hebilla y el broche del cinturón
de seguridad del carro. Aprietelas.
(Figura B)
Paso 6.
Asegúrese de que el asiento de
bebé para el auto esté bien sujetado.
Pruebe la instalación en para asegurar que
el asiento esté fijo al porta asiento en
todas direcciones.
NOTA: Puede que el asiento de bebé
para el auto tenga un indicador de nivel.
No es necesario usarlo con esta el asiento
portatil y el indicador puede quedar fuera
de la zona recomendada. El indicador de
nivel es para usar mientras el asiento de
bebé para el auto esté en un automóvil.
Para sacar el asiento
infantil
Paso 7.
Desabroche las cintas de
seguridad y sáquelas de las hebillas del
cinturón.
Paso 8.
•Con una mano agarre el mango del
asiento infantil (en su posición vertical
de acarreo).
•Con la otra mano, agarre el asiento
infantil cerca de los pies. Jale con
cuidado por la parte delantera del
asiento y levantelo. (Figura C)
S38-R5 12/02

Advertisement

loading