Pnp/Pci Configurations - Foxconn 915M03 Series Manual

PnP/PCI Configurations

vReset Configuration Data (Default: Disabled)
This option is used to set whether the system is permitted to automatically
distribute IRQ DMA and I/O addresses when each time the machine is turned
on. The setting values are Disabled and Enabled.
vResources Controlled By (Default: Auto (ESCD))
This option is used to define the system resource control scheme. If all cards
you use support PNP, then select Auto (ESCD) and the BIOS will automatically
distributes interruption resources. If the ISA cards you installed not support-
ing PNP, you will need to select " Manual" and manually adjust interruption
resources in the event of hardware conflicts. However, since this motherboard
has no ISA slot, this option does not apply.
vIRQ Resources
When the Resources Controlled By set as " Manual" , this option will be
modified. Press the <Enter> key, then manually set IRQ resources.
vPCI/VGA Palette Snoop (Default: Disabled)
If you use a non-standard VGA card, use this option to solve graphic accelera-
tion card or MPEG audio card problems (e.g., colors not accurately displayed).
The setting values are Disabled and Enabled.
vINT Pin 1-8 Assignment (Default: Auto)
This option is used to name the interrupt request (IRQ) line assigned to a
device connected to the PCI interface on your system.
vMaximum Payload Size (Default: 4096)
This option is used to set maximum TLP payload size for PCI Express devices.
The unit is byte. The available setting values are: 128, 256, 512, 1024, 2048,
4096.
60
PnP/PCI Configurations Menu
915M03 Series User Manual
Chapter 3 BIOS Description