Troubleshooting; Maintenance And Care - Kärcher PS 40 Powerscrubber Quick Manual

Application
Attaching the extension tubes
Fasten the PS 40 to the high-pressure gun
using the extension pipes.
Illustration
1 Screw the extension pipe (3) all the way
onto the thread of the PS 40 screws.
2 Connect the extension pipe (4) to the
extension pipe (3).
Illustration
1 Press the extension pipe (4) into the
bayonet catch of the high pressure gun.
2 Turn it by 90° until it locks into place.
3 Firmly turn the safety sleeve onto the
high pressure gun.
Note: In the unpressurised state, the exten-
sion pipe can be aligned to the PS 40. In
the high-pressure mode the extension tube
is fixed.
Cleaning floor surfaces
Illustration
Place the PS 40 onto the surface to be
cleaned.
Turn your high pressure cleaner on and
pull the lever of the high pressure gun.
Illustration
Wet, smooth surfaces can be dried us-
ing the built-in pull-off lip.
4 English

Troubleshooting

Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
High pressure cleaner does not
build up the pressure or is vibrating.
Check and clean the built-in high pressure
nozzles and filters of your PS 40.
Illustration
Remove the high pressure nozzles and
the filters.
1 Remove the clip.
2 Pull out the high pressure nozzle and fil-
ter.
Clean the filter and high pressure noz-
zle under running water.
Rinse the PS 40 with clear water.
Illustration
Reinstall the high pressure nozzles and
the filters.
1 Insert the high pressure nozzles with
the filter.
2 Re-insert the clip.

Maintenance and care

Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
Use a moist cloth and clean the PS 40 after
use.
Maintenance
The PS 40 is maintenance-free.
Care