Remote Control Operation - Roberts robi Manual

iPod Remote Control operation
1. Carefully plug
connector is correctly aligned (see Connecting to your iPod, page 25). Plug
the headphones into
2. Your iPod may power up when
Play / Pause button on
up after 2 - 3 seconds. The display will show 'Welcome' and then
enter the last used operating mode.
3. If necessary, press and release the Mode button until Remote mode is selected.
will show 'Remote' on the display.
4. Use the controls on your iPod to select the Artist / Album / Playlist as normal.
You can then optionally set the hold switch on your iPod.
5. Use the Play / Pause button on
6. Set the volume using the Volume Up and Down buttons on
23
into your iPod docking connector checking that the
.
is connected. If not, press and hold the
to switch on your iPod.
to start playback from your iPod.
will then power
will
.