Connecting the FM Antennas
FM Antenna (supplied)
1
Connect the FM antenna supplied to the FM COAXIAL Jack.
2
Slowly move the antenna wire around until you find a location where reception is good, then fasten it
to a wall or other rigid surface.
• This unit does not receive AM broadcasts.
Note
Cooling Fan
The cooling fan supplies cool air to the unit to prevent overheating.
Please observe the following cautions for your safety.
• Make sure the unit is well-ventilated. If the unit has poor ventilation, the
temperature inside the unit could rise and may damage it.
• Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or
ventilation holes are covered with a newspaper or cloth, heat may build up
inside the unit and fire may result.)
19
Setting the Clock
For each step, you have a few seconds to set the required options.
If you exceed this time, you must start again.
1
2
Switch the system on
Press TIMER/CLOCK
by pressing POWER
twice.
button.
•
"CLOCK" is displayed.
When the correct
3
4
Press ENTER.
hour is displayed,
The hour flashes.
press ENTER.
The minutes flash.
•
Increase the hours :
•
•
Increase the minutes :
Decrease the hours :
•
Decrease the minutes :
5
When the correct
time is displayed,
press ENTER.
•
"TIMER" appears in the display.
•
The current time is now set.
Note
•
You can display the time, even when you are using another
function, by pressing
TIMER/CLOCK once.
•
You can also use
on the main set instead of
buttons in step 3,4.
ENG
20