Connecting The Fm And Am(Mw) Antennas; Setting The Clock - Samsung MM-X7 Instruction Manual

Connecting the FM and
AM(MW) Antennas
AM Loop Antenna
(supplied)
FM antenna connection
1. Connect the FM antenna supplied to the FM 75Ω
COAXIAL terminal as a temporary measure.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75Ω coaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
11
If FM reception is poor,
connect an outdoor FM
antenna (not supplied).
FM
Antenna
(supplied)
AM antenna connection
(MW)
1. Connect the AM loop antenna supplied
to the AM and terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).

Setting the Clock

For each step, you have a few seconds to set the required options.
If you exceed this time, you must start again.
1 Switch the system 2
Press TIMER/CLOCK
on by pressing
twice.
POWER button.
•
CLOCK is displayed.
When the correct
When the correct
4 5
hour is displayed,
time is displayed,
press ENTER.
press ENTER.
The minutes flash.
• •
Increase the minutes : "TIMER" appears in the display.
• •
Decrease the minutes : The current time is now set.
Selecting the Video Format
Turn off the main unit and then press and hold NT/PAL button on the remote controller for over 5 seconds
•
By default, the video format is set to "PAL".
•
"NTSC" and "PAL" will appear in the display.
At this time,press the NT/PAL button shortly to select between "NTSC" and "PAL".
•
Each country has a different video format standard.
•
For normal playback, the video format of the disc must be the same as the video format of your TV.
Checking the Remaining Time
Press the REMAIN button.
•
For checking the total and remaining time of a title or chapter being played.
Each time the REMAIN button is pressed
TRACK ELAPSED
CD
TRACK REMAIN
TOTAL ELAPSED
TOTAL REMAIN
3
Press ENTER.
The hour flashes.
•
Increase the hours :
•
Decrease the hours :
Note
• You can display the time, even
when you are using another
function, by pressing
TIMER/CLOCK once.
.
12