Download Print this page
Hellenbrand TNT Series Specifications

Hellenbrand TNT Series Specifications

Tnt series water conditioners

Advertisement

Quick Links

TNT SERIES
WATER CONDITIONERS
For Commercial & Industrial Applications
Apartment Buildings
Boiler Water Treatment
Car Washes
Commercial Buildings
Condominiums
Factories
Hospitals
Laundries
Mobile Home Parks
Motels and Hotels
Nursing and Rest Homes
Office Buildings
Restaurants
Schools

Advertisement

loading

Summary of Contents for Hellenbrand TNT Series

  • Page 1 TNT SERIES WATER CONDITIONERS For Commercial & Industrial Applications Apartment Buildings Boiler Water Treatment Car Washes Commercial Buildings Condominiums Factories Hospitals Laundries Mobile Home Parks Motels and Hotels Nursing and Rest Homes Office Buildings Restaurants Schools...
  • Page 2: Front View

    The five cycle TNT controller is available with either downflow (co-current) or upflow (counter-current) brining, with easy adjustable cycle times. The TNT Series offers you a choice of mechanical or microprocessor controlled meter demand systems, with two-inch or three-inch meter turbines. All systems are fac- tory-wired and tested electrically to assure easy installation and correct operation.
  • Page 3 TN2 Standard System Design Options (for more specific information on the various system designs, contact your local Hellenbrand representative or go to: www.hellenbrand.com Single Tank Systems - XT Controller • Time Clock • XT Controller Electronic Meter Demand Twin, Tri-Plex & Four-Plex Systems - 3200NXT Controller Parallel Operation •...
  • Page 4: Top View

    TNT Series . MINERAL TANK: Poly Glass™ Composite tank with Poly- ethylene Inner Shell and Fiberglass Roving Manufactured to Operate at 150 psi. NSF Approved. B. DISTRIBUTOR SYSTEM: Three-Inch Hub & Lateral Distribution for Maximum Service Flow and Minimal Pressure Loss.
  • Page 5 SideMount Where ceiling heights may pose a restriction or a side-mounted configuration is preferred, TNT Series systems are available in this design configuration. Factory pre-piped and pressure tested, these system designs must be shipped either skid mounted or have face piping dis-assembled for shipment and re-assembled at the job site. Available with non-corrosive polyglass composite tanks or steel.
  • Page 6 TNT Service Rates & Pressure Drop Charts TNT-300 3” Service Rates & Pressure Drop Chart FLOW RATE G.P.M. TNT-600 3” Service Rates & Pressure Drop Chart FLOW RATE G.P.M. TNT-450 3” Service Rates 11/92 & Pressure Drop Chart FLOW RATE G.P.M. TNT-750 3”...
  • Page 7: Pressure Drop Charts

    Pressure Drop Charts TNT-900-48 3” Service Rates & Pressure Drop Chart FLOW RATE G.P.M. Commercial/Industrial Tanks TNT-1200 3” Service Rates & Pressure Drop Chart 11/92 High Grade Polyethylene Tank Liner • Fiber-free inner surface suitable for all standard water treatment applications. •...
  • Page 8 4. Flex connectors and vacuum breakers are required when using the PolyGlass Composite mineral tanks. 5. Backwash flow rates are calculated at 4 gpm per sq. ft. of bed area and rounded off based on 50ºF water temperature. TNT Series Fiberglass Dimensions with Six-Inch Flange Opening...

This manual is also suitable for:

Tnt-300-24Tnt-300-30Tnt-450-30Tnt-450-36Tnt-600Tnt-750 ... Show all