Impex Competitor WM-203 Owner's Manual page 10

STEP 5 (See Diagram 5)
A.) Attach the ball end of the Cable to the Pulley (#30). Place the Pulley in the open slot on
the Upper Lat Bar Frame. Secure it with one M10 x 2" Hex Bolt (#40), two Pulley
Bushings (#29), and one M10 Aircraft Nut (#47).
B.) Slide the Weight Holder (#11) onto the Lower Lat Bar Frame (#12) from the bottom.
Connect the Cable to the Holder with a Hook (#32).
C.) Connect the Upper Lat Bar Frame (#52) to the Lower Lat Bar Frame. Secure it with four
M8 x ¾" Hex Bolts (#41) and four Ø 5/8" Washers (#45).
D.) Connect the Lat Bar (#13) to the Cable with a Hook (#32). When using the Lat Pull
Down, remove the Arm Curl and place it in the storage post behind the Rear Upright
Beam. Then Insert the Lat Bar Frame into the opening on the Front Stabilizer.
8
DIAGRAM 5