Operation; Turning On The Scanner/Setting Volume And Squelch; Scanning The Channels; Turning Channel-Storage Banks On And Off - Radio Shack PRO-2037 Owner's Manual

OPERATION
TURNING ON THE
SCANNER/SETTING
VOLUME AND SQUELCH
1. Turn
SQUELCH
fully counterclock-
wise.
SQUELCH
2. Turn
VOLUME
clockwise until you
hear a hissing sound. The scanner
automatically scans all 10 banks.
VOLUME
3. Slowly turn
SQUELCH
clockwise,
then leave it set to a point just after
the hissing stops.
Note: If the scanner picks up un-
wanted weak transmissions, turn
SQUELCH
clockwise to decrease the
scanner's sensitivity to these signals.
If you want to listen to a weak or dis-
tant station, tum
SQUELCH
counter-
clockwise.
14
SCANNING THE
CHANNELS
To begin scanning the channels or to
start scanning again after monitoring
a channel, press
SCAN.
The scanner
scans either up or down through all
non-locked channels in the active
banks (see "Locking Out Channels").
To change the scanning direction,
press A or
T.
Note: An improper
SQUELCH
setting
might keep your scanner from scan-
ning. See ''Turning on the Scan-
ner/Setting Volume and Squelch."
TURNING
CHANNEL-STORAGE
BANKS ON AND OFF
When you first turn on the scanner,
the scanner scans all ten channel-
storage banks. As the scanner scans
a bank, the bar under the bank's num-
ber flashes.
To turn off banks while scanning,
press the bank's number key until the
bar under the bank's number disap-
pears. The scanner does not scan
any of the stored channels within
banks you have turned off.
Notes:
• You cannot turn off all banks.
There must be at least one active
bank.
• You can manually select any chan-
nel in a bank, even if the bank is
turned off.