Table of Contents
Advertisement
S-S.LOG
: Lets you select the signal stalker logging settings.
When this option is on, scanner checks log channel along with user programmed channels.
3.
Repeatedly press
[S-S.bnd]
S-S.bnd
If you selected
29-54
: VHF Low Band
108-137
: AIR Band
137-225
: VHF High Band
400-512
: UHF Band
800-956
: 800MHz Band
Repeatedly press
[Other than S-S.band]
Proceed to Step 4.
4. Repeatedly press
or
5. When you select the option, press
Using signal stalker
To turn on Signal Stalker, turn SQL fully clockwise, then press
or program mode.
appears. Every 2 seconds, the scanner searches for frequencies in the range you
specified in "Setting the Signal Stalker Options."
When the scanner finds a frequency, it sounds the alert you specified in "Setting the Signal Stalker Options",
Found
and
flashes. Press any key to confirm the displayed frequency. Press
scanning.
To turn on Signal Stalker and turn off normal scanning,
Flashes. See "Setting the signal stalker options on page XX.
To turn off Signal Stalker and turn on normal scanning, press
Trunking
Operation
The scanner tracks transmissions that use the Motorola Type I, Type II, hybrid,
and EDACS and LTR analog trunking systems. The frequencies for many of the 800 MHz,
900 MHz, and EDACS and LTR public safety systems are listed in the separate
National Public Safety Trunked System Frequency Guide included with your scanner.
or
to select the option you want, then press
, one of the following band names appears:
or
to select the band you want to set, then press
ON or OFF
to select
・/CLR /DELAY
E/PGM
, then press
.
E/PGM
to exit the option mode.
except in WX search, program search range,
S-S.OnlY
turn
of signal stalker options to on.
.. and.
. disappears.
.
E/PGM.
to resume
HOLD/RESUME
.
Hide quick links:
Advertisement
Table of Contents
