Evaporator Reassembly - Follett HCC1400A Operation And Service Manual

Evaporator reassembly

1. Remove and inspect O ring seal. Discard if
damaged in any way.
2. Clean O ring groove. Lubricate O ring with
petrol-gel and reinstall.
3. Press new mating ring into main housing as shown.
4. Lube the shaft with liquid soap in the area shown
and slip on seal and spring.
Note: Do not touch the sealing surfaces. Use
cardboard disk to install.
5. Reinstall main housing as shown.
Fig. 18
Fig. 19
Lube
with soap
Do not
touch
Fig. 20
20
Cardboard
disc