Troubleshooting Guide - Hunter CEILING FAN TYPE 2 Installation Instructions Manual

PROBLEM
1. Nothing happens;
fan does not move.*
*NOTE: If blades will not turn by hand, contact your nearest service representative.
2. Noisy operation.
3. Excessive wobbling.
When switching from medium to low speed, you may notice some fan wobble. When fan stabilizes at low speed, wobble will disappear.
©1998 HUNTER FAN CO.
FORM NO. 41201-01 1/95

TROUBLESHOOTING GUIDE

PROBABLE CAUSE
1. Power turned off or fuse blown.
2. Loose wire connections or wrong
connections.
3. Motor reversing switch not engaged.
4. Pull chain switch not "on".
1. Blade brackets loosely screwed to motor.
2. Blade screwed loosely to blade bracket.
3. Blade cracked.
4. Non-approved speed control being used.
5. Light globe noisy.
1. Blade brackets not attached at proper
locations.
2. Unbalanced blades.
3. Fan too close to vaulted ceiling.
4. Loose blades or blade brackets.
5. Fan not secure on hanger assembly.
SOLUTION
1. Turn power on or replace fuse.
2. Loosen canopy, check all connections (turn
power off while checking).
3. Push switch firmly to one side or the other.
4. Pull switch chain.
1. Tighten screws until snug.
2. Tighten screws.
3. Replace all blades.
4. Change to approved speed control.
5. Adjust globe mounting screws.
1. Carefully review Step 9.
2. Use balancing kit. (See Step 9C.)
3. Lower or move fan.
4. Tighten all screws.
5. Turn power off, support fan very carefully,
loosen canopy and hang correctly.
- 6 -
HUNTER FAN COMPANY
2500 FRISCO AVENUE
®
MEMPHIS, TN 38114, USA