Hunter CEILING FAN TYPE 2 Installation Instructions Manual page 2

Step 4: Installation of Ceiling Plate
A.
Install the (3) rubber bushings into the top of the ceiling
plate by inserting small side of rubber bushing into the three
round holes in the ceiling plate. See Figure 4.
Figure 4. Rubber Bushings
B.
Thread the lead wires through the opening in the ceiling
plate and install the ceiling plate to the 2 x 4 brace which sup-
ports the outlet box. Use (2) #10 wood screws 3" long and (2)
flat washers for mounting. Drill (2) pilot holes for mounting
screws 9/64" diameter. See Figure 4A.
RUBBER
BUSHING
FLAT WASHER
Figure 4A. Installing Ceiling Plate
Step 5: Fan Assembly
CAUTION: Do not lift motor by wires.
A.
Assemble the fan housing to the motor hanger adaptor. See
Figures 5 and 5A.
HOUSING
FORM NO. 41201-01 1/95
RUBBER
BUSHING
CEILING PLATE
CEILING PLATE
3" WOOD SCREW
#6-32 SCREWS
WITH LOCKWASHERS
MOTOR HANGER ADAPTOR
Figure 5
NOTCH IN TOP OF FAN HOUSING
ASSEMBLY SCREW LOCATION (1)
(3) PLACES
ASSEMBLY SCREW
LOCATION (3)
Top view of housing and motor hanger adaptor
showing parts alignment and assembly screws locations
B.
Before attaching the housing to the motor adaptor first align
the (3) notches in the top of the cover with the (3) matching tabs
on the adaptor.
Place the housing onto the adaptor making sure the tabs on the
adaptor fit into the notches in the housing. The housing should
sit flat on the adaptor.
Assemble the housing to the adaptor using (3) #6-32 screws with
lockwashers furnished in the sack parts. Make sure you use the
(3) screw locations located above. Tighten the screws.
C.
Assemble bottom cover to fan housing using (3) #6-32
screws and lockwashers supplied in sack parts. Make certain
screws are tight (see Figure 5B).
HOUSING
#6-32 SCREWS
WITH LOCKWASHER
- 2 -
TAB ON TOP OF ADAPTOR
ASSEMBLY SCREW
LOCATION (2)
Figure 5A.
BOTTOM COVER
Figure 5B
©1998 HUNTER FAN CO.