Fuse And Lamp Replacement - American DJ DJ Spot 250 User Instructions

DJ Spot 250™
Stand-Alone Operation (Sound Active):
unit or several units linked together, to run to the beat of the music.
1. Press the ESCAPE (ESC) button until "A.001" is displayed.
Then press the UP button until "AUDI" is displayed. Press the
ENTER button.
2. Press the UP button to display "YES". Press ENTER to con-
firm.
3. You can adjust the audio sensitivity of the unit by turning the
audio sensitivity knob clockwise, located in the rear.
invert the pan and tilt functions by in the system menu by follow-
ing the directions on page 13.
Note: When the unit is in Sound Active mode, "test run" will
flash on the LCD screen.
Master-Slave Operation (Sound Active):
you to link up to 16 units together and operate without a controller. The
units will be sound activated. In Master-Slave operation one unit will
act as the controlling unit and the others will react to the controlling
units programs. Any unit can act as a Master or as a Slave.
1. Using standard XLR microphone cables, daisy chain your units
together via the XLR connector on the rear of the units. Remem-
ber the Male XLR connector is the input and the Female XLR
connector is the output. The first unit in the chain (master) will use
the female XLR connector only - The last unit in the chain will use
the male XLR connector only. For longer cable runs we suggest a
terminator at the last fixture.
2. Set all Slave units to the same DMX address as the Master.
American DJ - www.americandj.com - DJ Spot 250™ Instruction Manual Page 17
© ®
Operation
This mode allows a single
You may
This function will allow
DJ Spot 250™
This fixture is fitted with a halogen lamp which is
highly susceptible to damage if improperly han-
dled. Never touch the lamp with your bare fingers
as the oil from your hands will shorten lamp life.
Also, never move the fixture until the lamps have
had ample time to cool. Remember, lamps are
not covered under warranty conditions.
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
technician. Replacing with anything other than the specified part can
damage your unit and will void your manufactures warranty.
Warning:
If you continue to blow lamps or fuses, STOP using the
unit. Contact customer support for further instructions, you may have
to return the unit for servicing. Continuing to use the unit may cause
serious damage.
Lamp Replacement:
Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power
and allow the unit ample time to cool before attempting to replace the
lamp. Lamp replacement has been made simple by incorporating the
use of a slide out socket assembly that is retained by thumb screws.
1. Be sure to follow the proper handling procedures that deal with
discharge lamps.
2. Remove the two small screws (A,B) on the rear of the unit
3. After removing the screws, gently slide out the socket assembly
from the rear of the unit to expose the lamp.
4. Carefully remove the old lamp and discard it in the trash.
5. Replace the lamp with an exact match and reassemble in reverse
order.
6. After replacing the lamp follow the optimization procedures on the
next page to be sure the lamp is center in the reflector
A
American DJ - www.americandj.com - DJ Spot 250™ Instruction Manual Page 18
© ®
Fuse & Lamp Replacement
service
®
B