Advertisement
Mobile Beam™/Mobile Ray™
You will want to remove the front of the unit to access the dip-
switches, as you would do when changing the lamp. Please
be careful when doing this. Remember to disconnect the main
power and allow the fixture time to cool down.
American DJ
- www.americandj.com - Mobile Beam™/Mobile Ray™ User Manual Page 7
©
®
Dipswitch Location
Dipswitches
Mobile Beam™/Mobile Ray™ Reset & Lamp Replacement
Halogen Lamp Warning:
with halogen lamps which are highly susceptible
to damage if improperly handled. Never touch the
lamps with your bare fingers as the oil from your
hands will shorten lamp life. Also, never move the
fixture until the lamps have had ample time to cool.
Remember, lamps are not covered under warranty
conditions.
Caution:
Always replace with the exact same type lamp, unless oth-
erwise specified by an authorized American DJ
Replacing with anything other than the specified part can damage
your unit and will void your manufactures warranty.
Warning:
If you continue to blow the lamp or breaker, STOP using
the unit. Contact customer support for further instructions, you may
have to return the unit for servicing. Continuing to use the unit may
cause serious damage.
Lamp Replacement:
Caution! Never open the unit when it is in use.
Always disconnect the main power and allow the fixture ample time to
cool before attempting to replace the lamps. Again, please remember
to always replace with the exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew the two thumb screws on the front of the unit.
3. Once the thumb screws have been removed, remove the lamp
assembly cover to expose the lamp.
4. Remove and replace the lamp
5. Reassemble in reverse order.
Breaker Reset: This unit is equipped with a built-in safety breaker. This
breaker is designed to close the power circuit in the event of an internal
short or power surge. This will reduce the risk of electrical shock or fire
and protect the circuitry. To reset the breaker, push the breaker button
in until you hear it "pop" back in to place. If the breaker continues to
pop, stop using the unit and contact our customer support team, the
unit may need to be returned for service.
For any other service related issues, please contact American DJ
customer support.
American DJ
- www.americandj.com - Mobile Beam™/Mobile Ray™ User Manual Page 8
©
®
This fixture is fitted
service technician.
®
®
Advertisement
