Advertisement
Gobo Flash 4™
Sound Active Operation:
the beat of the music without any type of controller.
1. Mount your units in a safe and secure manner.
2. Connect the "slave" units to the "master" unit as detailed in the
illustration below.
3. If you wish to use the optional remote control, connect it now. The
remote control will allow you to activate a blackout mode.
4. Connect the unit to main power.
5. The unit will now react to the low frequencies of music via the
internal microphone.
Master
Slave 1
Linking System:
Your Gobo Flash 4™ system comes with built-in
programs for a four unit system. Follow the step above for proper
linking and set-up procedures. If the system is not set up completely,
blank spots will appear in the programs.
Gobo Wheel:
Each unit contains an internal gobo wheel. The pro-
jected gobo can be changed by manual turning the wheel. To change
the gobo pattern, open the lamp assembly hatch on the top of the
unit, reach inside and turn the wheel to until you reach your desired
pattern.
Replacement Wheel: An optional "Special Occasion" gobo wheel
may purchased separately. For more information on this wheel, con-
tact your dealer or check our web site.
American DJ
- www.americandj.com - Gobo Flash 4™ Instruction Manual Page 7
©
®
Operation
This function allows a system to run to
Optional MINI/C Remote Control
Slave 2
Gobo Flash 4™
Gobo Flash 4™
Caution:
otherwise specified by an authorized American DJ
cian. Replacing with anything other than the specified part can dam-
age your unit and will void your manufactures warranty.
Slave 3
Warning:
using the unit. Contact customer support for further instructions, you
may have to return the unit for servicing. Continuing to use the unit
may cause serious damage.
Lamp Replacement:
use. Always disconnect the main power and allow the fixture ample
time to cool before attempting to replace the lamps. Again, please
remember to always replace with the exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew the thumb screw on the top of the unit.
3. Once the thumb screw has been removed, remove the lamp
socket assembly cover to expose the lamps.
4. Remove and replace the lamps with an exact match.
5. Reassemble in reverse order.
For any other service related issues, please contact American DJ
customer support.
American DJ
©
Halogen Lamp Warning:
with halogen lamps which are highly susceptible
to damage if improperly handled. Never touch the
lamps with your bare fingers as the oil from your
hands will shorten lamp life. Also, never move the
fixture until the lamps have had ample time to cool.
Remember, lamps are not covered under warranty
conditions.
Always replace with the exact same type lamps, unless
If you continue to blow lamps one after another, STOP
Caution! Never open the unit when it is in
- www.americandj.com - Gobo Flash 4™ Instruction Manual Page 8
®
Halogen Lamp Warning
This fixture is fitted
Lamp Replacement
service techni-
®
®
Advertisement
