Configuration; Performing An Upgrade; Choosing The Audio Input Mode - ADDER AdderLink XD522 User Giude

Configuration

Performing an upgrade

AdderLink XD522 units are flash upgradeable using the method outlined here.
The same upgrade file is used to upgrade both the transmitter and receiver units
(although they are upgraded individually).
Warning: During the upgrade process, ensure that power is not
interrupted as this may leave the unit in an inoperable state.
1 Download the upgrade file from Adder's website.
2 Connect the supplied serial cable (VCS40) between your computer and the
Options port of the AdderLink XD522 unit to be upgraded.
3 Use a narrow implement (e.g. a straightened-out paper clip) to press-and-
hold the recessed reset button on the front panel until the indicators begin
pulsing.
Use a straightened-out
paper clip to press and
hold the reset button
until the front panel
indicators respond
4 With the unit in download mode, transfer the upgrade file using an XMODEM
file transfer via any terminal emulator program. Use the following settings:
115200 baud, 8 bit word, no parity, 1 stop bit (8N1) and no flow control.
5 Upon completion of the download, the unit will begin to upgrade its stored
firmware. Once this process has completed the unit will reboot itself and
begin to operate with the new firmware.
Finding the latest upgrade files
Firmware files for the units are available from the Support > Firmware
Updates section of the Adder Technology website (www.adder.com).

Choosing the audio input mode

The AdderLink XD522 receiver has two analog audio inputs: A microphone
socket on the front panel and a Line In
You can choose between these two analog inputs using a hotkey switch, as
follows:
To choose between the Line In and Microphone inputs
1 Using a USB keyboard attached to one of the USB A ports on the AdderLink
XD522 receiver, press the
the three keyboard indicators will all flash, once per second.
2 Use the numeric keys located above the main section of the keyboard (not
the numeric keypad), to choose the required action:
to select Line In mode. The
confirm your selection.
to select Microphone mode. The
confirm your selection.
The chosen socket will be patched through (via the link cable) to the Line
Out socket of the transmitter.
socket on the rear.
key three times in succession. In response,
icon will be displayed on screen to
icon will be displayed on screen to
20