Pro-Form 365s CROSSWALK User Manual page 7

2, With the heUpof another person, carefully Uower the
Uprights (69) as shown, Note: Utmay be heUpfuU to pUace
one foot on one of the Extension Legs (63) as you tip the
Uprights, Make sure that the Extension Legs remain
in the Uprights.
Attach each Extension Leg (63) with two 1" Tek Screws
(39) and a Round Base Pad (57) as shown, Attach the
tower Tek Screw, without the Round Base Pad, first.
Attach two more Round Base Pads (57) to the base of
the Uprights (69) with two 1" Tek Screws (39), Note: One
repUacement Round Base Pad may be included, ff a
Round Base Pad becomes worn and needs to be re-
pUaced, use the repUacement Round Base Pad,
Attach the two WheeUs (66) with two 2" BoUts(64) and
two WheeU Nuts (32) as shown, Do not overtighten the
BoJts; the WheeUs shouUd be aMe to spin freeUy,
With the heUpof another person, carefully raise the
Uprights (69) to the verticaU position,
3. With the heUpof a second person, tip the treadmHUso the
Base (not shown) is fiat on the floor.
hsert the tab on one of the Handrail Brackets (40) into the
suet in the right Upright (69), Attach the Handrail Bracket
with a 3/4" Screw (2), Attach the other Handrail Bracket to
the left Upright (not shown) as described above,
\
/
66
64
69
69 66 64
_9
4, Identify the Right Handrail (72), which has a large hole in
the left side, Feed the Upright Wire (42) into the hole in
the bottom of the Right Handrail and out of the large hole
in the side, Note: It may be helpful to use needlenose pli-
ers to pull the Wire Harness out of the hole,
Press a Handrail Cap (16) onto the lower end of the
Right Handrail (5) as shown,
Set the Right Handrail (72) on the right Upright (69), with
the the lower end inserted into the Handrail Bracket (40),
Attach the Right Handrail (72) with an Upright Bolt (37) in
the upper end and a 3/4" Screw (2) in the lower end,
Attach the Left Handrail (71) as described above, Note:
There is not a wire harness on the left side,
/
71
Hole
Hole
7