R
M
EMOVING THE
1.
Set the feed direction knob on the TCP to REVERSE.
Figure 3-18. Set the feed direction knob to REVERSE.
2.
Push the feed flow lever down to open the feed circuit.
Figure 3-19. Push the feed flow lever down to supply
power to the feed drive.
3.
Push the feed speed knob down to 6.5 gpm (maximum
flow).
E.H. Wachs
ACHINE
Part No. 10-010-MAN, Rev. 1-0310
Chapter 3, Operating Instructions: Performing the Cut
33