P
ERFORMING THE
1.
Push the feed flow lever down to open the feed circuit.
Figure 3-12. Push the feed flow lever down to supply
power to the feed drive.
2.
Set the feed speed knob to 2.5 gpm.
Figure 3-13. Push the feed speed knob down to
2.5 gpm.
E.H. Wachs
C
UT
Part No. 10-010-MAN, Rev. 1-0310
Chapter 3, Operating Instructions: Performing the Cut
The cutting wire spins at very
high speed. If the wire
breaks, segments of the wire
can fragment and be thrown
from the machine at danger-
ous speeds. Make sure all
personnel are at a safe dis-
tance before starting the cut-
ting drive. Serious injury or
death could result from
contact with the wire or as
a result of the wire break-
ing.
WARNING
29