Rigging The Machine - Wachs WS-8460 User Manual

Diamond Wire Saw User's Manual
Clamp pressure gauges
Clamping flow levers (engage
both at once—shown closed
under pressure)
10
Cutter pressure gauge
Cutter
speed
Clamp
direction
Cutter flow lever
(shown open)
Figure 1-9. The photo shows the controls on the top-
side control unit. (The fourth circuit, to the far right, is
not used with the subsea wire saw.)

Rigging the Machine

A rigging instruction label is attached to the top of the
machine frame on WS-164 through WS-5230 models. See
the end of this section for information on rigging the WS-
8460 model.
Figure 1-10. The rigging label is on top of the frame.
Part No. 10-010-MAN, Rev. 1-0310
Feed speed Feed pressure gauge
Feed flow lever
(shown open)
Feed
direction
E.H. Wachs