Clamping System - Wachs WS-8460 User Manual

Diamond Wire Saw User's Manual
8

Clamping System

An adjustable clamping system allows you to configure the
machine for pipe sizes within each model's range. The two
clamping arms are attached to the main frame with two-
pronged forked pins that are removable to reposition the
arms.
The clamping arms are engaged by hydraulic cylinders
mounted to the frame. When the cylinder rods are extended,
the clamps pivot inward to grip the underside of the pipe
and hold the machine securely to it. Figure 1-6 illustrates
the clamping operation.
See "Adjusting Clamp Arms for the Pipe Size" later in this
chapter for information on the clamp position settings for
each wire saw model.
Clamping arm
pivots to con-
tact pipe
Figure 1-6. The photo shows the wire saw in position
for clamping on a test workpiece. When the hydraulic
cylinder is extended, the clamp arm pivots and closes
on the pipe. Both clamping arms operate together.
Part No. 10-010-MAN, Rev. 1-0310
Clamping
motion
Clamping
cylinder
E.H. Wachs