Kenmore Elictronic 27" Wide Electric Dryers Owner's Manual page 15

Typical installations
for rear exhausting -
straight
(see p. 17)
This dryer may be converted to exhaust
out the right or left side or through the
bottom. To convert the dryer, the follow-
ing kits MUST be used.
Exhaust Kit No. 279818 (white)
Exhaust Kit No. 279819 (almond)
Exhaust Kit No. 279820 (ebony)
Follow the instructions in the kit to
avoid operational and personal hazards.
These kits are available at your local
SEARS store or service center.
Typical installations
for left or right side
exhausting
'I
Typical installations
for bottom exhausting
OFFSET CONNECTIONS;
Maximum Exhaust Lengths:
, Rear Exhaust. The maximum length.
of the rear exhaust system depends
on the type of duct, the number of
elbows and the type of exhaust hood.
Refer to the chart below.
• Side or Botton7 Exhaust. Side or bot-
tom exhaust adds a 90 ° turn inside the
dryer. To determine maximum exhaust
length, add one 90 ° turn to the chart.
EXHALIST HOOD TYPE
Number of
90 ° Turns !
0
1
2
3
4
0
1
2
3
4
Maximum length of 4-inch
diameter rigid metal duct.
64 ft. 58 ft.
54 ft. 48 ft.
44 ft. 38 ft.
35 ft. 29 ft.
27 ft. 21 ft.
Ivlaximum length of 4-inch
diameter flexible metal duct.
36 ft. 28 ft.
31 ft. 23 ft.
27ft. 19ft.
25ft. 17ft.
23ft. 15ft.
Avoid pushing the dryer tightly against
a wall. This can crush or kink the duct.
Use the straightest path you can, where
possible, to avoid 90 ° turns.
15