Kenmore Elictronic 27" Wide Electric Dryers Owner's Manual page 12

Do Not use an extension cord with
this dryer.
Do Not connect plug end of power
supply cord into a live receptacle before
connecting power supply cord to dryer
terminal block.
STEP 1. Turn power supply off.
STEP 2. Remove hold-down screw
and terminal block cover.
Hold-down
screw
Terminalblock
cover
STEP 3. Attach 3/4" U.L.-listed strain
relief (U.L. marking on strain relief) to
the hole below terminal block opening.
Put the power supply cord through
the strain relief.
STEP 4. Remove the center terminal block
screw. Remove the neutral grounding
wire (green/yellow wire) from external
grounding screw.
Externalground
connector
Center silver-colored
terminal block screw
STEP 5. Connect neutral grounding wir_
and the neutral wire. (white) of power
supply cord under the center screw of
terminal block.
STEP El. Connect the other two insulate(
wires to outer terminal block screws. Us_
the same method described in STEP 4.
STEP 7. Connect the green, grounding
wire fro'n the power supply cord to the
externar grounding conductor screw.
Tighten all terminal [)lock screws firmly.
STEP 8. Tighten the strain relief screws.
STEP 9, Insert tab of terminal block
cover inLo slot of the dryer rear panel.
Secure oover with hold-down screw.
Centersilver-
External coloredterminal Whiteneutral
ground blockscrew wire
connector
Green wire Neutral
of power sllpply grounding wire
cord or bare (green/yellow)
copper wire
Strainrelief
4-Wire Connection with
Frame-.Grounding Conductor
Continue Installation on Page 14,
"CONNECT EXHAUST."
Green/yellow wire
of harness
12